1. Standby with the right hand four fingers hold the seat, the thumb naturally placed on the top of the fuselage cover. Smooth hold the machine;
2. Thread the thread on the spool gently. And then through the lead coil. The thread is temporarily placed next to the needle, the other thread from the needle in front of the needle (to the fuselage joint) through the pinhole, and then thread into the needle into the small hole, About 2-3 cm pressure plate pressure can be used;
3. release: with the right hand index finger lift the pressure plate, will be ready to be sewn fabric (thickness of not more than 0.8mm) flat into the pressure plate, gently put back pressure plate to suppress the fabric;
4. Sewing operation: with the left hand holding the fabric, right hand thumb gently press the top of the top cover pressure in the end, the thumb and then pressure, and then Dayton, so repeated, the feeder will automatically be sent to the left , Holding the right hand gradually shifted to the right. Left hand with the sewing rhythm will be stitched to the left to move until the end of sewing; with scissors cut the thread, gently pull out the press under the fabric. From the opposite side of the fabric, pull out the last thread, so that it is inserted into the next section of a coil tightening and playing a knot. Pin on the solid, left hand at the end of the way to not pull the thread to pull the thread, so as not to pull bad machine needle, pin.
5. The machine automatically into the cloth and adjust the elastic between the pins, but pay attention to the following points is necessary: the pin is too tight, the pressure nut slightly counterclockwise tone; pin too loose, the pressure nut slightly clockwise; The correct pin is tight, if the need for larger pins, pull the left hand faster, if the need for some of the needle, the left hand can be slightly slower;
6. Change the line: If you use a large wire group, the spare pole can be connected with the spool shaft connection, into a large line of the body, the spare plastic shaft placed at the end of the pole fixed large line group, and then threading, Adjust the line after the tightening of the sewing; the use of cotton or synthetic line the best results;
7. Replace the needle: loosen the fixing screw and remove the broken needle. Note that the needle should be flattened to face the fixing screws.